Straight key build (2): First 3D print.

Note: 11/29/22.  I am going to put this project on hold while I order some springs.  I plan to redesign it, preferably using OnShape.   -Steve 

Below is how the key goes together after fitting the parts in TinkerCad

This is the first print of the morse key: 

Unfortunately it's a no go.  I forgot to add support underthe the key platform and the printer to fail construct the underside of the platform 

You can se in the photo above that the bottom of the elevated part of the key platform is just loose filaments. 

The above photo shows my conception of how its supposed to fit together.  There is no assembly drawing or BOM included.  It needs a spring and various screws.  There is also some sort of shaft and bearing that go where lever connects to the key base...  It's a mystery!  I'm going to investigate how the parts fit together before printing the next try, with the support added.