3D printing: Garage wall bracket

 I am getting pretty familiar with Fusion 360 now...  it's pretty simple....   sketch then extrude, sketch then extrude, sketch then extrude....

I needed a simple bracket to hold a digging bar against my garage wall for starage and threw a model together in about 20 minutes. See Fusion 360 screen shot below:

A quick drawing is shown below to indicate size. The bracket is 3" wide:

The finished and installed bracket is shown below.  I anchored to the wall using  hollow wall anchors.  A nail in the bracket retains the digging bar in the bracket. 

click to enlarge