This is my first cut at the SWR project box design. I used the sheet metal options in Fusion 360 to design a two piece sheet metal box with dividers. The box is 3" wide by 4.5" deep.
click to enlarge
The division of the box into shielded compartments can be seen with the top removed. Four pieces are cut from 0.8 mm aluminum: 1) the base, 2) the top, and 3) the dividers.
click to enlarge
The sheet cutout patter for the base is shown below. Dimensions in mm.
click to enlarge
Cutout pattern for the top are shown below. Dimensions are in mm.
click to enlarge
Cutout pattern for the basic divider is given below, later versions may need a separate version for each divider. Dimensions are in mm.
click to enlarge
No comments:
Post a Comment